If the LINE OUT level is to low.
Make sure that the Line Out knob is turned clockwise to it's max. Be careful though,

ProCue 1m1's line out level is higher than the standard.

If Auricle is used to trigger the build in click generators in ProCue 1m1 it is important
that "TESLA CLICK BOX" is set to "OFF". The old Tesla box worked with MIDI

velocities in another way than we do today. If some other software is controlling the

clicks make sure that the velocities is not to low. If the line out signal is still to low
the click velocity sensitivity can be turned off in the setup menu.

Missing SYNC POP / missing Punch after streamer.
When ProCue 1m1 generates Sync or a streamer with a following punch the Sync pop

and the punch will be generated in sync with a video frame shift. Some consumer

video decks emit a invalid field sync pulse in "paused" or "stopped" mode that
prevents the ProCue 1m1 from trigger the sync pop or punch. To solve the problem

let the videotape run or turn off the video deck.

If the Video LED (fig.1-20) is lit solid, ProCue 1m1 has recognized an incoming
video signal. But ProCue 1m1 can't detect if the signal has incorrect frame/field

information.

Missing events when using text, streamers and clicks at the same time.

Try to move some of the midi events to other MIDI channels. Could be like this:
Streamers: MIDI channel 16

Clicks: MIDI channel 15

Sync pop: MIDI channel 14

If you MIDI sequenser has the possibility to turn "Running Status" off, then try that.

SPECIFICATIONS
Dimensions: 1.75"(h) x 8.5"(d) x 19"(w)

Weight: 5.5 lbs.

Video in/out: 1 Vpp 75 ohm
S-Video in/out: Y = 1 Vpp 75 ohmC = 0.7 Vpp 75 Ohm.

Audio In sensitivity: IN A (1/4 inch phono): 125 mV, IN A (XLR): 250 mV
Line out: Balanced

IN B: TTL 5 volt in/ relay closure.

TTL out: 5 volt
Power consumption: 30 Watt

22