TROUBLESHOOTING

No visual events are generated, when sending out MIDI note on commands to

ProCue 1m1.

1)If the MIDI LED is flashing when MIDI is send out of the controller:

Check that the configuration for NOTE/SYSEX is correct.

Make sure that the used MIDI channel is the MIDI channel for visual events.

2)If the MIDI LED is not flashing when MIDI is send out of the controller:

Check the MIDI Cable

No difference between the width of Click and Click 2.

The TONE control could be set to high.

The MIDI notes stored for CLICK 1 or CLICK 2 or SYNC POP is not

responding:

1)If the MIDI LED is flashing when MIDI is send out of the controller:

The MIDI channel for CLICK 1 or CLICK 2 or the SYNC POP could be the

same as the MIDI channel for the VIDEO events. In that case the MIDI note
numbers are fixed to the default note numbers. See CLICK 1, CLICK 2,

SYNCPOP and VIDEO in SETUP.

Make sure that the transmitting MIDI channel is the one assigned for the
function.

2)If the MIDI LED is not flashing when MIDI is send out of the controller:

Check the MIDI Cable and the controlling devise.

Rainbow colored streamers:
The video in signal is to low. Could happen if there is a "T" (video signal splitter)

between the video deck and the ProCue 1m1.