SETUP

How to set up ProCue 1m1

If a monitor is connected the Video Out (Fig. 2-3) all settings can be seen on the

monitor unless the third secondary function "Show settings on screen" is set to

"OFF".
The LEDs fig. 1-23 to 1-34 are part of the set up procedure. The LEDs fig. 1-27 to 1-

32 are working in pairs.

Three buttons are used in the set up procedure.

1) SETUP button (fig. 1-19)
The SETUP button brings ProCue 1m1 in and out of SETUP mode. The SETUP LED

(fig. 1-18) will blink slowly when ProCue 1m1 is in SETUP mode. When pressed

once the main functions settings will be displayed when pressed twice the secondary
functions settings will be displayed. When pressed the third time ProCue 1m1 goes

out of SETUP mode because there is no third functions yet.
Note:The SETUP button does not store changes.

2) NEXT button (fig. 1-15)
Moves the setup "pointer" to the next function in the rows of LEDs and ProCue 1m1

will be ready to change the setting for that function where the LED is now blinking

slowly or lit solid.
Note:The NEXT button does not store changes.

3) SET button (fig. 1-16)

The SET button works in 2 different ways.

1) For functions with only one linked LED (Click 1, CLICK 2, SYNC POP and
VIDEO) the "SET" button will assign the already received MIDI note

number/channel to the given function.

2)For functions with two linked LEDs (From Vel.ON/Vel.OFF fig. 1-27)

the "SET" button will switch between the two linked LEDs or as a third option turn

them both on if the function has that possibility. The chosen setting will be

remembered.

Press the SETUP button once or twice depending on the current setup page, to exit

SETUP mode. The SETUP LED will stop blinking.